Installation Instructions - Frigelux CB255RCA++ Manuel D'utilisation

3.

INSTALLATION INSTRUCTIONS

Location
When selecting a location for your appliance you should make sure the floor is flat and firm,
and the room is well ventilated. An average ambient temperature must be observed. Your
appliance is a N-ST class.
This temperature is specific according to the climatic class of the device:
 SN: This refrigerating appliance is intended to be used at ambient temperatures
ranging from 10 °C to 32 °C
 N: This refrigerating appliance is intended to be used at ambient temperatures
ranging from 16 °C to 32 °C
 T: This refrigerating appliance is intended to be used at ambient temperatures
ranging from 16 °C to 38 °C
 ST: This refrigerating appliance is intended to be used at ambient temperatures
ranging from 16 °C to 43 °C
Avoid location near a heat source, eg, cooker, boiler or radiator. Also, avoid direct sunlight
in out-buildings or terraces/outside seating areas. If you are placing your appliance in an
out-building such as a garage or annex ensure that it is placed above the damp course,
otherwise condensation will occur on the cabinet. Never place the appliance in a wall
recessed or into fitted cabinets or furniture when it is working, the metal grid at the back may
become hot and the sides warm. This refrigerating appliance is not intended to be used as
a built-in appliance Never place the Fridge/Freezer in a wall recessed or into fitted cabinets
or fumiture when your Fridge/Freezer is working, the grille at the back may become hot and
the sides warm. It must therefore be installed so that the back of the Fridge/Freezer has at
least 9cm (31/2") of free space and the sides have 10 cm (3/4"). Do not drape the
Fridge/Freezer with any covering.
Leveling the appliance
If your appliance is not leveled, the door and magnetic seal alignment
will be affected and may cause a malfunction. Once the appliance is
placed in its final location, adjust the leveling feet at the front by turning
them.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate of soda. Then rinse
with warm water using a damp sponge or cloth. Wash the baskets and shelves in warm
soapy water and dry completely before replacing them.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the appliance.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE APPLIANCE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30
minutes before switching back on to allow the coolant fluid to settle.
Before filling your appliance
Before storing foods in your appliance, turn it on and wait for 24 hours, to make sure it is
working properly and to allow it to reach the correct temperature.
25