Troubleshooting; Specifications - Sony CDP-CE575 Mode D'emploi

Troubleshooting

If you experience any of the following
difficulties while using the player, use this
troubleshooting guide to help you remedy the
problem. Should any problem persist, consult
your nearest Sony dealer.
There's no sound.
• Check that the player is connected securely.
• Make sure you operate the amplifier correctly.
• Adjust the analog output level with ANALOG
OUT LEVEL +/– on the remote.
The CD does not play.
• There's no CD inside the player. "–NO DISC–"
appears. Insert a CD.
• Place the CD with the label side up on the disc
tray correctly.
• Clean the CD (see page 23).
• Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour.
• Place the CD in the correct position on the disc
tray.
The recording level has changed.
• The recording level changes if you adjust the
analog output level with ANALOG OUT
LEVEL +/– on the remote during recording.
The remote does not function.
• Remove the obstacles in the path of the remote
and the player.
• Point the remote at the remote sensor
player.
• Replace all the batteries in the remote with new
ones if they are weak.
The player functions incorrectly.
• The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it back
on to reset the player.
24
US

Specifications

Compact disc player
Laser
Frequency response
Dynamic range
Harmonic distortion
Outputs
ANALOG
OUT
DIGITAL
OUT
(OPTICAL)
PHONES
General
Power requirements
Power consumption
Dimensions (approx.)
(w/h/d)
Mass (approx.)
Supplied accessories
on the
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (1)
R6 (size AA) batteries (2)
Monaural (2P) mini-plug cable (1)
Design and specifications are subject to change
without notice.
Semiconductor laser (λ =
780 nm)
Emission duration:
continuous
2 Hz to 20 kHz ± 0.5 dB
More than 93 dB
Less than 0.0045%
Jack Maximum
type
output level
Phono 2 V
jacks (at 50 kilohms)
Optical –18 dBm
output
connector
Stereo 10 mW
phone
jack
120 V AC, 60 Hz
11 W
430 x 110 x 400 mm
(17 x 4 3/8 x 15 3/4 in.)
incl. projecting parts
5.2 kg (11 lbs 8 oz)
Load
impedance
Over 10
kilohms
Wave
length:
660 nm
32 ohms