Switch Lock Function; Shut Down - Hoshizaki DCM-60KE-HC Notice D'utilisation

4) Replace the front cover in its correct position.
[b] Adjusting portion control
1) Remove the front cover.
2) Press and hold the portion control switch on the control panel for 3 seconds. The display shows the current portion control
setting for ice dispensing.
3) Press the flashing ice (-) switch or water (+) switch on the operation panel to adjust the amount of ice. The value in the display
decreases or increases by "1" every time the switch is pressed (e.g. "06" = 60g).
[DCM-60/120KE-HC]
4) Press the portion control switch on the control panel. The display illuminates "PORTION".
5) Replace the front cover in its correct position.
[DCM-60/120KE-P-HC]
4) Press the portion control switch on the control panel. The display goes off and illuminates the setting again when it is stored.
Then, the display shows the current portion control setting for water dispensing.
5) Press the flashing ice (-) switch or water (+) switch on the operation panel to adjust the amount of water. The value in the
display decreases or increases by "1" every time the switch is pressed (e.g. "15" = 150mL).
6) Press the portion control switch on the control panel. The display goes off and illuminates the setting again when it is stored.
Then, the display illuminates "PORTION".
7) Replace the front cover in its correct position.

5. SWITCH LOCK FUNCTION

Pushing the lock switch on the control panel locks the ice switch, ice & water switch, and water switch operations. The switch
lock function is deactivated in the default setting.
1) Remove the front cover.
2) Select your dispensing choice by pushing ice switch, ice & water switch, or water switch on the operation panel. The selected
switch flashes. Press the lock switch on the control panel. The lock lamp on the operation panel lights up.
3) To deactivate the switch lock function, press the lock switch again. The lock lamp goes off.
4) Replace the front cover in its correct position.

6. SHUT DOWN

This ice dispenser must be shut down and drained every day at the end of service hours.
1) Move the ice making switch, located on the right side of the ice dispenser, to the "OFF" position.
[DCM-60/120KE-HC]
2) Check that the lock lamp on the operation panel is off. If it is on, press the lock switch on the
control panel to deactivate the switch lock function.
3) Press the ice switch on the operation panel. The ice switch lights up.
4) Place a large container right under the dispensing outlet, and keep pressing the push lever until
no more ice is dispensed.
5) Remove the front cover.
[DCM-60/120KE-P-HC]
2) Press and hold the ice switch, ice & water switch, and water switch at the same time for 3 seconds. The dispense switch
flashes, and the continuous dispensing becomes available.
Note: To deactivate the continuous dispensing, move the ice making switch to the "ON" position or remove the front cover.
9
ENGLISH