Simpson MS60763-S Manuel D'utilisation page 9

Connect Spray
4
Wand to Spray
Gun
Thread the spray wand into
the end of the spray gun.
Release Air from
7
System
Release all air from
pump and high pressure
hose by depressing
trigger until a steady
stream of water is present.
Approximately 30 seconds.
30 S
Gradually move the
10
Lever to the FAST
Position after
engine starts.
See label #10 on the engine.
WARNING: This Guide is not a substitute for reading the operator's manual. User must
read and understand operator's manual before using this product.
Connect QC
5
Nozzles to Spray
Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure in coupler.
Move the Lever to
8
the CHOKE
Position
See label #8 on the engine.
9 - ENG
Turn Water
6
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
Pull the Recoil
9
Starter Grip
Pull the
recoil starter grip to
start the engine.
See label #9 on unit.