Accessories; Standard Accessories; Optional Accessories - Hitachi DH 38YE2 Mode D'emploi

English
6. Service and repairs
All quality power tools will eventually require
servicing or replacement of parts because of wear
from normal use. To assure that only authorized
replacement parts will be used, all service and
repairs must be performed by a HITACHI
AUTHORIZED SERVICE CENTER, ONLY.
7. Service parts list
CAUTION:
●
Repair, modification and inspection of Hitachi
Power Tools must be carried out by a Hitachi
Authorized Service Center.
WARNING:
ALWAYS use Only authorized HITACHI replacement parts and accessories. NEVER use replacement parts or
accessories which are not intended for use with this tool. Contact HITACHI if you are not sure whether it is
safe to use a particular replacement part or accessory with your tool.
The use of any other attachment or accessory can be dangerous and could cause injury or mechanical
damage.
NOTE:
Accessories are subject to change without any obligation on the part of the HITACHI.

STANDARD ACCESSORIES

(1) Case (Molded plastic) (Code No. 326489) ............ 1
(2) Side Handle (Code No. 313078) ............................ 1
(3) Dust Cover (Code No. 993245) ............................. 1
(4) Stopper (Code No. 971786) ................................... 1
OPTIONAL ACCESSORIES.....sold
separately
For accessories in detail please call HITACHI AT 1-800-
59-TOOLS
1. Through-hole drilling (Rotation + Hammering)
(1) Drill bit (Spline shank)
External dia. Overall lenght
1"
(25 mm)
16"(400 mm)
1-1/2"
(38 mm)
12
This Parts List will be helpful if presented with
the tool to the Hitachi Authorized Service Center
when requesting repair or other maintenance.
In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
MODIFICATIONS:
Hitachi Power Tools are constantly being improved
and modified to incorporate the latest
technological advancements.
Accordingly, some parts may be changed without
prior notice.

ACCESSORIES

2. Anchor hole drilling (Rotation + Hammering)
(1) Drill bit
(2) Taper shank adaptor
A-taper
B-taper
Code No.
3. Large-dia. hole boring (Rotation + Hammering)
985375
985376
(Guide plate)
Code No.
985388
955169
(3) Cotter
(2) Taper shank adaptor
(Taper shank)
Taper shank adaptor formed
A-taper or B-taper is provided
as optional accessory, but drill
bit for it is not provided
(1) Center pin (2) Core bit
Code No.
955165
4-1/8" (105 mm)
(Code No. 944477)
(Spline shank)
Code No. 985377
Code No. 985378
(3) Core bit
shank
External dia.
(Spline
2" (50 mm)
shank)