Interrupting The Wash Cycle; Delay Start; Changing The Wash Cycle - Bosch SHX3AR7 UC Série Notice D'utilisation

9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.

Delay start

You can delay the start of the
program by 3, 6 or 9 hours.
Switch on ON/OFF switch (.
1.
Keep pressing the Preselected
2.
starting time button 0 until the
appropriate display 3h, 6h or 9h
is lit.
Press START button h, timer
3.
programming is activated.
To delete the preselected starting
4.
time, keep pressing the
Preselected starting time button
0 until none of the displays 3h,
6h or 9h is lit.
You can change your program
selection at any time until the
program starts.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button h again.
Operating the Dishwasher en-us

Interrupting the wash cycle

9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
Press On/Off button (.
1.
The LED's go out. The wash cycle
is saved.
To continue the wash cycle, close
2.
the door and press On/Off button
( again.
Your dishwasher is protected
Note:
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button h again.
Terminating the wash cycle
(Reset)
Press and hold Start button h
1.
for approximately 3 seconds.
Wait about 1 minute while the
2.
dishwasher drains.
Press On/Off button (.
3.
You may now power the dishwasher
back on and begin a new cycle if
desired.

Changing the wash cycle

When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
27