Setting The Amount Of Rinse Aid Used - Bosch SHX3AR7 UC Série Notice D'utilisation

Setting the amount of rinse
aid used
The amount of rinse aid dispensed
can be set in 4 levels. Accordingly
0, 1, 2 or 3 displays are lit.
Factory setting: 1.
You should only change the setting if
streaks remain on the dishes (lower
the amount), or if dishes are not
getting dry enough (increase the
amount).
Open the door.
1.
Switch on ON/OFF switch (.
2.
Hold down button > P
3.
and press START button h
until the clean indicator )" and
the sanitized indicator lights `
flash.
Release buttons.
4.
Keep pressing button > P until
5.
the rinse aid refill indicator )*
flashes.
The rinse aid refill indicator )*
flashes and the display # is lit
(= Setting 1).
To change the setting:
Press the button < H until
1.
the required setting has been
selected.
Press START button h.
2.
The displays )" and )* go out.
The selected setting is saved.
Close the door.
3.
Turning off rinse aid
indicator
Proceed as described in the section
"Setting the amount of rinse aid
used" and set value to 0. The rinse
aid indicator is now turned off.
NOTICE
Using no rinse aid or setting the
dispenser to 0 may result in longer
cycle times consuming more energy
and water. The higher temperatures
and longer cycle times can damage
fine china or glassware.
Rinse Aid en-us
13