Adding Rinse Aid; Setting The Amount Of Rinse Aid Used - Bosch SGE68X55UC Notice D'utilisation

Adding rinse aid

NOTICE
To avoid oversudsing or clogging, do
not overfill the rinse aid
dispenser 9*. Wipe up any spills
with a damp cloth.
Open the rinse aid dispenser 9*
1.
by pressing on the latch of the lid
and pull it open.
Add liquid rinse aid to the
2.
dispenser 9* until it is full. Do
not overfill. Avoid spilling into air
vent hole.
Close the lid. Lid must be fully
3.
closed until it clicks in order to
seal.
Wipe up any excess rinse aid that
4.
may have puddled when the
dispenser reservoir is full.
The indicator light will go out a few
moments after the dishwasher door
is shut.
For easier pouring, remove lid
Tip:
from the rinse aid bottle.
NOTICE
Do not fill the rinse aid dispenser 9*
with detergent. Doing so will damage
the dishwasher.
Setting the amount of rinse
aid used
The amount of rinse aid dispensed
can be set from §:‹‹ to §:‹‡. The
factory setting is §:‹†.
You should only change the setting if
streaks remain on the dishes (lower
the amount), or if dishes are not
getting dry enough (increase the
amount).
Setting Amount
dispenser is OFF
§:‹‹
lowest setting
§:‹‚
low setting
§:‹ƒ
medium setting
§:‹„
medium/high setting
§:‹...
high setting
§:‹†
highest setting
§:‹‡
Press the On/Off button (.
1.
Hold down the function key #
2.
and press the Start button P
until the display 8 indicates
•:‹x or š:‹x (x can be any
number). Release both buttons.
Press the function key # until
3.
the display 8 shows §:‹†.
Press the function key 3 to
4.
select the desired setting.
Press the Start button P to
5.
save the setting.
Rinse Aid en-us
15