Table des Matières
Publicité
Anleitung_RT_XS_28_SPK1:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Additional handle
2. Operating switch
3. Speed controller
4. Handle
5. Dust container
6. Rectangular sanding/grinding plate
7. Eccentric sanding/grinding plate
8. Triangular sanding/grinding plate
9. Punch for sanding/grinding paper
10. Chip extractor adapter
11. Allen key
3. Proper use
The equipment is designed for the grinding/sanding
of wood, iron, plastic and similar materials using the
appropriate grinding/sanding paper. The machine is
not suitable for wet grinding/sanding.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
10
02.09.2010
7:43 Uhr
Seite 10
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains voltage:
Power input:
Orbits:
Protection class:
Weight:
Rectangular sanding/grinding plate:
Grinding/sanding area:
Abrasive paper size
(Velcro fastening system):
Abrasive paper size
(clamping system):
Eccentric sanding/grinding plate:
Grinding/sanding area:
Abrasive paper size:
Triangular sanding/grinding plate:
Abrasive paper size:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
sound pressure level
pA
K
uncertainty
pA
L
sound power level
WA
K
uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
230 V~ 50 Hz
280 W
0 – 10,000 rpm
II /
2.2 kg
140 x 115 mm
140 x 115 mm
180 x 115 mm
Ø 125 mm
Ø 125 mm
82 x 109 x 106 mm
(a x b x c; see Fig. 1)
80 dB(A)
3 dB
91 dB(A)
3 dB
Publicité
Table des Matières
