Assembly; Fitting The Loop Handle; Assembling The Cutting Equipment - Husqvarna 335LS Série Manuel D'utilisation

Fitting the loop handle

• Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Slide the spacer into the slot in the loop handle.
• Fit the nut, knob and screw. Do not overtighten.
• Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.

Assembling the cutting equipment

WARNING!
!
When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
!
attachment. If the cutting attachment is
fitted incorrectly it can result in serious
and/or fatal personal injury.
WARNING! Never use a cutting attachment
!
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
• Fit the trimmer guard/combination guard (A) intended for
use with the trimmer head/plastic blades.
Hang the trimmer guard/combination guard (A) on the
two hooks on the plate holder (M). Bend the guard
around the shaft and tighten it with the bolt (L) on the
opposite side of the shaft. Use the locking pin (C). Place

ASSEMBLY

the locking pin in the groove on the screw head and
tighten. See diagram.
M
• Fit the drive disc (B) on the output shaft.
H
B
• Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
• To dismantle, follow the instructions in the reverse order.
L
A
C
–
English 35