Door Reversal Instructions; Important - Danby DCR023C1W-MOL2 Guide D'utilisation Et Soins De Propriètaire

Installation Instructions
DOOR REVERSAL
INSTRUCTIONS

IMPORTANT

• Ensure the appliance is unplugged and
empty.
• We recommend that 2 people handle the
refrigerator during assembly.
• Adjust the 2 leveling feet to their highest
position.
Tools Required
Cross-bladed screw driver - Phillips head
NOTE:
• To take the door off it is necessary to tilt the
appliance backward.
DO NOT lay the appliance completely flat as
this may damage the coolant system.
If you find the direction of opening the door on your appliance
inconvenient, you can change it by following the diagram below.
CAUTION
To avoid personal injury to yourself and/or property, we recommend
someone assist you during the door reversal process.
1 Remove the plastic hole covers
which are located on the top left
side of the refrigerator as shown in
Figure 1.
2 Remove the upper hinge and hinge
cover on the right side of the refrig-
erator, as shown in Figure 2.
3 Remove the door and incline the refrig-
erator at an angle of 45 degrees. You
should rest the refrigerator against
something solid so that it will not slip
during the door change process. Do
not lay the refrigerator flat as this may
damage the coolant system. On the
underside of the refrigerator, remove
the lower hinge bracket on the right
side and the leveling foot on the left
side and reverse their positions as
shown in Figure 3.
4 Install the lower hinge on the left side
on the bottom of the refrigerator.
Install the adjustable foot on the right
side as shown in Figure 4.
5
Figure 1
Figure 2
Figure 3
Figure 4