Door Reversal Instructions - Danby DFF092C1WDB Manuel Du Propriétaire

OPERATING INSTRUCTIONS

DOOR REVERSAL INSTRUCTIONS

If the appliance is placed on its back or side for any length of
time during this process, it must be allowed to remain upright
for 6 hours before plugging it in to avoid damage to the
internal components.
1. Remove the hinge cover and the upper hinge. Remove
the hinge hole covers from the top left side of the cabinet.
Remove the refrigerator door from the cabinet.
2. Remove the screws from the center hinge. Remove the
center hinge, the center hinge spacer and the freezer door.
3. Move the bushing from the top right side to the top left side
of the freezer door.
4. Remove the right door stop from the bottom of the freezer
door.
5. Remove the lower hinge from the right side of the cabinet,
then install the lower hinge on the left side of the cabinet.
6. Get the left door stop from the accessory bag, install it on
the bottom left side of the freezer door.
7. Remove the center hinge screw hole plugs and install them
in the screw holes on the right side of the cabinet.
8. Install the freezer door. Install the center hinge. Ensure that
the center hinge spacer is installed with the center hinge
as the spacer is necessary to allow the doors to have
full range of motion. Get the left upper door stop from
the accessory bag, install it on the bottom left side of the
refrigerator door.
9. Install the refrigerator door. Install the upper hinge and
hinge cover on the top left side of the cabinet. Before
tightening the screws on the upper hinge, ensure that the
top of the door is level with the cabinet and that the rubber
gasket is making a good seal. Install the screw hole covers
on the top right side of the cabinet.
A. Hinge Cover
B. Screws
C. Upper Hinge
D. Hinge Hole Cover
E. Center Hinge Spacer
F. Center Hinge
G. Door Bushing
H. Right Door Stop
I. Lower Hinge
J. Left Door Stop
K. Screw Hole Cover
1
2
3
4
5
6
7
8
9
5
A
D
B
C
E
F
G
B
G
H
B
I
B
J
B
K
E
F
G
B
A
D
B
C