Door Reversal Instructions - Danby Designer DCR032C1BSLDD Manuel Du Propriétaire

OPERATING INSTRUCTIONS

DOOR REVERSAL INSTRUCTIONS

If the appliance is placed on its back or side for
any length of time during this process, it must
be allowed to remain upright for 6 hours before
plugging it in to avoid damage to the internal
components.
1. Remove the plastic hole covers located on the
top left side of the refrigerator as shown in Fig.
1.
2. Remove the upper hinge cover and the upper
hinge on the right side of the refrigerator, as
shown in Fig. 2.
3. Remove the door from the lower hinge pin by
pulling it gently upwards. Remove the lower
hinge bracket on the right side of the unit and
remove the leveling foot on the left side. Reverse
their positions as shown in Fig. 3.
4. Install the lower hinge on the left side of the
refrigerator. Install the adjustable foot on the
right side of the refrigerator as shown in Fig. 4.
5. Move the door bushing to the left and the plastic
hole cover to the right as shown in Fig. 5.
6. If there is a door stopper, move it from the right
side of the appliance to the left as shown in
Fig. 6. If there are two door stoppers, there is
no need to move them. Install the door onto the
lower hinge pin, now located on the left side of
the appliance.
7. Install the upper hinge and hinge cover on the
left side of the unit. Place the plastic hole covers
in the holes on the right side of the top of the
refrigerator to cover the screw holes as shown in
Fig. 7.
Note: When installing the door, ensure that the top
of the door is level with the top of the cabinet. If the
door is not level, the rubber gasket will not make
a good seal with the cabinet which can cause the
appliance to malfunction.
1
2
7
5
3
4
5
6