Makita HR001G Manuel D'instruction page 14

► 1. Dust cup
Dust cup set
Optional accessory
Before installing the dust cup set, remove the bit from
the tool if installed.
Install the dust cup set on the tool so that the
bol on the dust cup is aligned with the groove in the tool.
► 1. symbol 2. Groove
NOTE: If you connect a vacuum cleaner to the dust
cup set, remove the dust cap before connecting it.
1
► 1. Dust cap
To remove the dust cup set, remove the bit while pulling
the chuck cover in the direction of the arrow.
1
► 1. Bit 2. Chuck cover
Hold the root of dust cup and pull it out.
sym-
1
2
NOTE: If the cap comes off from the dust cup, attach
it with its printed side facing up so that groove on the
cap fits in the inside periphery of the attachment.
OPERATION
CAUTION:
handle) and firmly hold the tool by both side grip
and switch handle during operations.
CAUTION:
piece is secured before operation.
CAUTION:
the bit gets stuck. Loss of control may cause injury.
14 ENGLISH
Always use the side grip (auxiliary
Always make sure that the work-
Do not pull the tool out forcibly even
1
2