Table Des Matières - Teac CD-2000 Mode D'emploi

Contents
Thank you for choosing TEAC. Read this manual carefully to
get the best performance from this unit.
Before Using the Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Discs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Identifying the Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Basic Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13
Before Using the Unit (1)
Read before operation
Be careful to avoid injury when moving the unit due to its weight.
o
Get someone to help you if necessary.
To protect easily scratched furniture, you may apply the felt pads
o
supplied with the unit to the feet.
As the unit may become warm during operation, always leave
o
sufficient space around the unit for ventilation. The ventilation
holes should not be covered. Make sure there is at least 20 cm (8")
of space above and at least 5 cm (2") of space on each side of the
unit. Do NOT place anything on top of the unit.
The voltage supplied to the unit should match the voltage that is
o
printed on the rear panel. If you are in any doubt regarding this
matter, consult an electrician.
Choose the installation location of your unit carefully. Avoid placing
o
it in direct sunlight or close to a source of heat. Also avoid locations
subject to vibrations and excessive dust, heat, cold or moisture.
Do not place the unit on an amplifier or any other device that
o
generates heat.
Do not open the cabinet as this might result in damage to the
o
circuitry or electrical shock. If a foreign object should get into the
unit, contact your dealer or service company.
When removing the power plug from the wall outlet, always pull
o
directly on the plug, never yank the cord.
Do not attempt to clean the unit with chemical solvents as this
o
might damage the finish. Use a clean, dry cloth.
Keep this manual in a safe place for future reference.
o
When the unit is turned on, if a TV is turned on nearby lines might
o
appear on the TV screen depending on the frequency of the TV
broadcast. This is not a malfunction of the unit or the TV. If you see
such lines, move the unit and the TV further apart.
5