BH FITNESS Tecnovita Mini bike Instructions De Montage Et Utilisation page 13

ASSEMBLY INSTRUCTIONS.
Take the unit out of the box and place
it on the floor as shown in Fig.1.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
(A) Main body;
Stabiliser bar; (B1) Rear stabiliser bar;
(D) Screw M-4x25; (E) Grower washer
M-4; Pedal combination spanner.
1.- FITTING THE
STABILISERS.
Take the stabilser (B) marked with the
letter (A) and place it at the front of the
unit marked with the letter (A), as
shoewn in Fig.2, insert the M-4x25
screws (D).
Next, take the rear stabiliser (B1)
marked with the letter (B), Fig.3, and
go through the same fitting procedure
as with the front stabiliser.
2 ATTACHING THE PEDALS.
Insert the pedals (C), onto the cranks,
Fig.4.
NOTE: Both pedals are threaded right.
Tighten well in the clockwise sense.
MAINS CONNECTION.
Connect the unit to a plug provided of
a ground (220v). Put the switch (L) in
position [1] Fig.6.
(C) pedals; (B)
REMOTE CONTROL.
Display indicator: Speed,
Time. Distance (Distance
traveled km) Calorie, Scan (The
random sample data display
speed, time, distance, calories).
1:
2:
button. (1-15 min).
3:
increasing speed (12 speed
levels).
4:
increasing speed (12 speed
levels).
5:
Change pedal direction key
6:
parameter display speed, time,
distance, calories
13
Power
Time-Time selection
Speed-- Select key for
Speed+- Select key for
Forward/reverse-
Mode-Select key for