Notes:
– To prevent splashing, fully immerse the
blender blade in the ingredients before
switching on the appliance.
– With liquid foodstuffs, immerse the
blender foot and hold it at a slight angle
for better blending results and to prevent
the ingredients from sticking to the
bottom of the receptacle.
– The appliance works better if there is
some liquid in the ingredients.
Care and daily cleaning
The appliance and the tools used must be
thoroughly cleaned after each use.
W Risk of electric shock!
– Unplug the appliance before cleaning it.
– Never immerse the base unit in liquids
and do not clean in the dishwasher.
– Do not steam-clean the appliance.
Caution!
– Do not use any cleaning agents
containing alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
– Do not wedge plastic parts in the
dishwasher as they could become
permanently deformed.
Please note:
– To make it easier to clean the blender
foot, after use place it in a receptacle
containing clean water and briefly press
the Turbo button  several times.
– When processing food such as red
cabbage or carrots, plastic parts may
become discoloured. This can be
removed with a few drops of cooking oil.
In Fig. C you will find a summary of how to
clean the individual parts.
■ Disconnect the base unit and the
accessory parts from one another.
■ Wipe the outside of the base unit with a
soft, damp cloth and dry off.
Care and daily cleaning
■ Clean the accessory parts with a
detergent solution and a soft cloth or
sponge or place them in the dishwasher.
■ Clean the blender foot in the dishwasher
or with a brush under running water.
■ Dry the blender foot in an upright
position (blender blade face up) so that
any trapped water can run out.
Note:
Appliances with a spiral cable:
Never wind the cable round the appliance!
Troubleshooting
Problem
Appliance switches off during use.
Remedy
The overload protection device has been
activated.
■ Disconnect the mains plug.
■ Leave the appliance to cool down for
approx. 1 hour in order to deactivate
the overload protection device.
■ Plug the mains plug into the mains.
Switch the appliance on again.
Important: If a fault cannot be eliminated,
please contact customer service.
Recipes
Mayonnaise
– 1 egg (egg yolk and egg white)
– 1 tbs. mustard
– 1 tbs. lemon juice or vinegar
– 200-250 ml oil
– Salt and pepper to taste
Ingredients must be at the same
temperature!
■ Put all ingredients in a jug.
■ Place the blender foot on the base
of the jug and blend until the mixture
emulsifies.
■ Slowly raise the switched on blender
as far as the upper edge of the mixture
and lower again until the mayonnaise
is ready.
en
13