Installing The Microphone - Sony XAV-AX3200 Mode D'emploi

Installing the microphone

To capture your voice during handsfree calling, you
need to install the microphone .

Clip (not supplied)
Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
• If airbags or any other shock-absorbing
equipment are in your car, contact the store where
you purchased this unit or the car dealer before
installation.
Notes
• When mounting on the dashboard, remove the visor clip
carefully from the microphone , then attach the flat-
mount base  to the microphone .
• Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.



Using the steering wheel remote
control
When using the steering wheel remote
control (XAV-AX3200 only)
Installation of the connection cable RC-SR1  is
required before use.
1
To enable the steering wheel remote
control, select [General]  [Steering Control]
 [Custom] 
to make the registration.
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable RC-
SR1  (XAV-AX3200 only)
REMOTE IN

Black

Green

Brown
• Before installing, turn on the car ignition then
check that the steering wheel control buttons are
working correctly.
• Refer to the support site for details then connect
each lead properly to the appropriate leads.
Making an improper connection may damage the
unit.
URL: https://www.sony.com/am/support
• Consulting the dealer or an experienced
technician for help is recommended.
When using an adaptor for the steering wheel
remote control
Depending on the type of car, use an adaptor for
the steering wheel remote control (not supplied).
1
Set [Steering Control] in [General] to
[Preset].
The adaptor for the steering wheel remote
control is enabled.
GND
Input 1
Input 2
15
GB