Ayce BV-C1536D Notice Originale page 65

Charge the battery (Fig.6)
Attention! Only use charger in dry places, away from moisture and heat sources.
Before first use, the battery needs to be charged for about 1-2 hours.
Use only the original charger.
1. Remove the battery from the device.
2. Align the sliding slots with the battery and slide the charger connector onto it until it
locks in place. (Fig.6-a, Fig. 6-b)
6
Fig. 6
Fig. 6-a
3. Connect the charger to the power supply. (LED on charger lights up red, and meanwhile
the LED on battery lights up green and blink)
4. After a sufficient charging time (about 2.5 hours, LED on charger lights up green),
disconnect the charger from the power supply.
5. Press the release button and remove the charger connector from the battery.
NOTE: It is normal for the battery and charger to become warm (but not hot) during
charging process. If the battery does not charge properly, check to make sure the
electrical outlet is "live".
5
Fig. 6-b
7
64 65