Ayce BV-C1536D Notice Originale page 58

IMPORTANT
READ CAREFULLY BEFORE USE.
KEEP FOR FUTURE REFERENCE.
SAFE OPERATING PRACTICES FOR HAND-HELD GARDEN BLOWERS
1) Training
a) Read the instructions carefully. Be familiar with the controls and the proper use of
the appliance.
b) Never allow children, persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge or people unfamiliar with these
instructions to use the machine. Local regulations may restrict the age of the
operator.
c) Keep in mind, that the operator or user is responsible for accidents or hazards
occurring to other people or their property.
2) Preparation
a) Obtain ear protection and safety glasses. Wear them at all times while operating
the machine.
b) While operating the machine always wear substantial footwear and long trousers.
Do not operate the machine when barefoot or wearing open sandals. Avoid wearing
clothing that is loose fitting or that has hanging cords or ties.
c) Do not wear loose clothing or jewellery that can be drawn into the air inlet. Keep
long hair away from the air inlets.
d) Operate the machine in a recommended position and only on a firm, level surface.
e) Do not operate the machine on a paved or gravel surface where ejected material
could cause injury.
f) Before using, always visually inspect to see, that fasteners are secure, the housing
is undamaged and that guards and screens are in place. Replace worn or damaged
components in sets to preserve balance. Replace damaged or unreadable labels.
g) Never operate the machine while people, especially children, or pets are nearby.
3) Operation
a) Keep your face and body away from the blowing opening.
b) Do not allow hands or any other part of the body or clothing inside the blowing
opening, discharge chute, or near any moving part.
c) Keep proper balance and footing at all times. Do not overreach. Never stand at a
higher level than the base of the machine. Always be sure of your footing on slopes.
Walk, never run.
d) Always stand clear of the discharge zone when operating this machine.
e) If the machine should start making any unusual noise or vibration, immediately
shut off the power source and allow the machine to stop. Remove battery and take
the following steps before restarting and operating the machine:
i) inspect for damage;
ii) replace or repair any damaged parts;