Dru SCENIC Instructions D'installation Et Mode D'emploi page 23

INSTRUCTIONS FOR INSTALLATION
NB: To ensure the ignition works properly,
5
the ignition wire must come into as little
contact as possible with the metal parts of
the heater and should therefore not be
wound round the gas or pilot-light pipes or
the thermocouple.
Build a chimney breast as shown in fig. 2.
Scenic
Fig. 2c is for a mounted chimney breast and
fig. 2b for a built-in chimney breast.
The DRU range includes suitable chimney
breasts.
LUX vent component
To ensure a good heat supply and discharge,
the chimney breast must be adequately
vented. A vent component, the LUX vent
component, is available from your installer.
The vent component serves to ventilate the
chimney breast.
7
fig. 1a
5
6
38C-1087
7
fig. 1b
Scenic
19