Safety Instructions; User Manual - Velleman VTSS5 Mode D'emploi

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be
returned to your distributor or to a local recycling service. Respect the local environmental
rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.

The device is equipped with an electronic, temperature-controlled analogue scale from 175 to 480°C.

The soldering iron is connected to ground.

Power is switched on or off by the temperature control button. A LED indicator lights up when the
device is on.
2.

Safety Instructions

Read and understand this manual and all safety signs before using this appliance.
This device can be used by children aged from 8 years and above, and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning the use of the device in a safe way and understand
the hazards involved. Children shall not play with the device. Cleaning and user maintenance
shall not be made by children without supervision.
If the power cord is damaged, it must be replaced by the manufacturer, its service agent, or
similarly qualified persons in order to avoid any hazard.
Do not use near inflammable products or in explosive atmospheres. Heat can cause fire to
inflammable products even when they are not in sight. Only use in properly ventilated rooms.
Do not touch the shaft or soldering tip as this can cause serious burns. Always return the
soldering iron to its stand between uses; always let it cool down after use and before storage.
Incorrect use may cause fire.
Always disconnect mains power when the device is not in use or when maintenance activities
are performed. Handle the power cord by the plug only. Do not crimp the power cord(s) and
protect against damage. Have an authorised dealer replace it if necessary.
Do not inhale solder fumes. The vapours that are released during soldering are harmful.
Therefore, you should only use the soldering station in well-ventilated areas or under an
exhaust hood (solder fume extractor).Dispose of solder residue in accordance with local
regulations.
Never use the device on live electronic circuits. Make sure power to the work piece is cut and
capacitors are discharged.
Warning: this tool must be placed on its stand when not in use; do not leave the tool
unattended when switched on.

The soldering station is to be used only for soldering/unsoldering electric and electronic components
in printed circuit boards and modules, for tinning PCB tracks and cable ends and for repairing cable
connections.

The soldering station may definitely not be used for heating liquids and synthetic materials
(formation of toxic vapours, fire hazard!)

A defective soldering station (visible damage, no function, prolonged storage in bad conditions,
improper shipping) mustn't be used and should be guarded against further use. The device should
only be repaired by qualified personnel.

The soldering station should only be used with an alternating current of 230V (220V-240V) 50Hz.

You shouldn't leave the soldering station at high temperatures for too long. Shut it off when you
don't intend on using it for a longer period.
V. 04 – 14/03/2018
VTSS5

USER MANUAL

3 ©Velleman nv