Testing The Detector - Velleman PIR700 Mode D'emploi

flat-mount
5.3 Connection
Risk of electroshock! Touching live wires can cause life-
threatening electroshocks.
 Have the device repaired by qualified personnel.
 Disconnect the power source.
 Cover and shield any adjacent live components.
 Ensure the device cannot be switched on.
 Make sure the power supply is disconnected.
1. Connect the necessary cables according to the wiring scheme
inside the detector's housing. Make sure all connections are
tightly secured.
2. Close the detector and switch on the power. Proceed with the test.
5.4

Testing the Detector

V. 02 – 14/04/2017
PIR700
4
corner-mount
©Velleman nv