Safety Instructions - Velleman WB043 Mode D'emploi

1.

Safety Instructions

 Do not begin the installation until you have read and understood the instructions and warnings contained in
this installation sheet.
 If you have any questions regarding any of the instructions or warnings, please contact your local
distributor.
 This mounting bracket was designed to be installed and utilized only as specified in this manual.
 Improper installation of this product may cause damage or serious injury.
 This product should only be installed by someone of good mechanical ability, with basic building
experiences and fully understanding of this manual.
 Make sure that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
 Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
 Tighten screws firmly, but do not overtighten.
 Overtightening can damage the items, greatly reducing their holding power.
 This product is intended for indoor use only.
 Using this product outdoors could lead to product failure and personal injury.
2. Component Checklist - Important
See images on page 2.
 Ensure that you have received all parts according to the component checklist prior to installing. If any parts
are missing or faulty, contact your local distributor for a replacement.
 Mounting hardware not included.
3. Mounting
3.1 Install decorative covers
See images on page 2.
 Attach decorative covers to wall plate using screws, with the gap of the decorative cover downward.
3.2 Wood stud wall mounting
See images on page 2.
 Mark the exact location of the mounting holes.
 Drill pilot holes.
 Screw the wall mount onto the wall.
Warnings
 Make sure that the mounting screws are anchored in the centre of the studs.
 The use of a stud finder is highly recommended.
 Installers are responsible for providing hardware for other types of mounting situations.
 The installer must verify that the supporting surface will safely support the combined load of the equipment
and all attached hardware and components.
3.3 Solid brick and concrete mounting
See images on page 2.
 Mark the exact location of the mounting holes.
 Drill pilot holes.
 Screw the wall mount onto the wall.
Warnings
 When installing wall mounts on cinder blocks, verify that the actual concrete thickness is at least 1-3/8"
(35 mm) for using the concrete anchors.
 Do not drill into mortar joints! Be sure to mount in a solid part of the block, generally 1" (25 mm) minimum
from the side of the block.
V. 01 – 10/04/2017
WB043
USER MANUAL
13 ©Velleman nv