Whirlpool W10477539B Instructions D'installation page 13

To Convert Gas Pressure Regulator
1. Open broiler door and remove broiler pan. The gas pressure
regulator is located in the back right hand corner of the broiler
compartment.
A
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
NOTE: Do not remove the spring beneath the cap.
2. Remove the cap from the gas pressure regulator using a
flat-blade screwdriver.
NOTE: Be sure sealing washer remains in the same position.
A. Cap
3. To convert to LP gas, unscrew the plastic adjustment screw
by hand, turn it over, and screw it in again.
Inlet pressure
to Natural gas
A
B
C
A. Cap
B. Sealing washer
C. Adjustment screw
4. Reinstall the cap.
A
Inlet pressure
to LP gas
180º
To Convert Surface Burners
1. Remove burner grate, burner caps and burners.
C
A
A. Burner cap
B. Burner
C. Center burner
2. Locate LP gas orifice spuds for top burners in the bag
containing literature included with the range. Three LP gas
spuds are stamped "78," and two are stamped "80."
3. Remove Natural gas orifice spuds using a 7 mm combination
wrench.
4. Install LP gas orifice spuds using a 7 mm combination
wrench.
A. Spud
B. Holder
NOTE: Depending on model, the range cooktop may be
equipped with 4 standard burners, 3 standard burners and
1 power burner, or 3 standard burners, 1 power burner and
1 center burner. Spud size/location remain the same.
A
B
A. Standard burner - LP gas orifice spud number 78
B. Power burner - LP gas orifice spud number 80
C. Center burner - LP gas orifice spud number 80
D. Standard burner - LP gas orifice spud number 78
E. Standard burner - LP gas orifice spud number 78
B
A
B
C D
E
13