Cresta DTX 250 Mode D'emploi page 24

Daily alarm set-up
•
Press "MODE" to switch from time display to AL display
•
Press and hold the key "MODE" for 3 seconds ,the flashing alarm time are shown
•
The hour display of the alarm time is flashing. Use "+" and "-" to select the hour.
Press "MODE" to confirm.
•
then follow the minutes. Use "+" and "-" to select the minutes,
Press "MODE" to confirm.
Daily alarm on/off
•
When showing AL alarm time, press "-" to activate the alarm with alarm symbol showing.
•
Press "-" again cancel the alarm when in AL
Information:
•
The clock automatically changes from set-up mode to time mode if no keys are pressed for
30 seconds.
•
The alarm sounds for 2 minutes if no key is pressed to stop it.
Snooze function
To activate the snooze function, follow the steps below
•
Press the key "SNOOZE/LIGHT", while the alarm sounds, to activate the snooze function.
•
If the snooze function is activated, a Snooze symbol is flashing.
•
The alarm repeat after 5 minutes.
•
The snooze function can be stopped by pressing any key.
12/24 hours mode
The time display can be in 12 （AM/PM）or 24 hours mode. Press "+" for exchange between
12/24 hours.
°C/°F temperature display
The temperature display can be in °C or °F. Press "-" to switch between the mode.
Max./ Min. for the indoor/outdoor temperature and humidity
Press "MAX/MIN" for displaying of indoor/outdoor max./min. of temperature and humidity.
4 Weather forecast
Sunny Slightly cloudy
Remarks：as the weather is forecasted by temperature humidity and air press only,
. The display will have discrepancy with the actual weather sometime.
Cloudy Rainy
23