Settings And Adjustments - Life & Mobility Vivo Mode D'emploi

a
Changing the seat width
B
Armrests
M
Change handlebar angle

Settings and adjustments

Adjust seat width
1. Loosen the socket screws (a) on the bottom­
rear of the seat.
2. Set the width to suit your personal
requirements.
3. Re­tighten the socket screws.
The arm rests are now locked in the current
position.
Armrests
Fold the armrests (B) up to make getting­out
easier.
Adjusting the steering angle
Attention:
ƒ Do not adjust the angle of the steering
column while driving.
Adjust the steering column so that you can easily
reach the controls and the display. The steering
column can be adjusted by a toothed­wheel.
1. Loosen the quick­release lever (M) at the
bottom of the steering column
2. Lift the steering column slightly out of the
toothed­wheel and adjust the steering
column to the required angle. Ensure that
the teeth on the wheel engage.
3. Re­tighten the quick­release lever.
The steering column is now locked in place.
Adjusting the seat height (3 positions)
1. Remove the seat.
2. Remove the battery box.
3. Loosen the bolt and adjust the seat column
to the required seating height.
4. Replace the battery box.
5. Replace the seat.
Disassembled mobility scooter
Unlocking
Determining the position
Assembling
GB16
Settings and adjustments
Dismantling
The mobility scooter can easily be dismantled
for transport or storage (see the 'Transport and
Storage' chapter also).
Warning:
ƒ Be very careful when dismantling the mobility
scooter. Ensure that your hands and fi ngers
do not get trapped in the hinge system.
D
1. Pull the unlocking lever (b) on the rear of
mobility scooter vertically upwards.
b 2. At the same time press the handle (D) toward
the ground.
3. Now, lift the front section away from the rear
section (Z).
Assembling
1. Tilt the rear section (Z) of the mobility
scooter at an angle of 45 degrees onto the
anti­tipping wheels.
Attention:
ƒ Determine the hook­in position accurately
to prevent damage to the body shell.
Z
2. Lift the front section of the mobility scooter
and carefully hook it onto the frame tube of
the lower rear section.
3. Allow the front section to lower gently, until
both sections click together.
GB17