Using Omnipass - Fujitsu LIFEBOOK S761 Guide D'utilisation

knuckle) towards yourself. Swiping too fast or too slow will result in a failed capture. The Choose Finger
screen has a [Practice] button; click it to practice capturing your fingerprint. When you are comfortable with how
your fingerprint is captured, proceed to enroll a finger.
3
Once OmniPass has successfully acquired the fingerprint, the Verify Fingerprint screen will automatically
appear. To verify your enrolled fingerprint, place your fingertip on the sensor and hold it there as if you were
having a fingerprint captured. Successful fingerprint verification will show a green fingerprint in the capture
window and the text Verification Successful under the capture window.
After you are done enrolling and verifying your fingerprints, you will have the option to Enable PBA with
4
enrolled finger. If you enable this option, then you must choose two fingers to save in PBA. If you have
enrolled successfully, the Finger Enrollment Status in PBA screen will state Finger saved in PBA
successfully.
I
F YOU ENABLE
B
ON OOT SETTINGS
S
ETTINGS

Using OmniPass

You are now ready to begin using OmniPass. Used regularly, OmniPass will streamline authentications.
Fingerprint Sensor LED Indications
Once OmniPass is installed, you will be able to determine the state of the fingerprint sensor by the
condition of the LEDs above and below the sensor.
• Flashing blue: Indicates your finger is on the sensor and it is ready to accept a fingerprint swipe.
• Flashing green: The fingerprint swipe was successful and the fingerprint was accepted.
• Flashing red: The fingerprint swipe was unsuccessful and the fingerprint was rejected.
PBA
ON YOUR SYSTEM
. S "S
EE ETTING THE
" 54
ON PAGE FOR ADDITIONAL INFORMATION
170 - Introducing the Optional Fingerprint Sensor Device
, S
YOU MUST SET THE UPERVISOR
S P
UPERVISOR ASSWORD AND
.
P P
ASSWORD AND ASSWORD
P B
ASSWORD ON OOT