Safety and environmental instructions
In case of malfunction, do not use
•
the product, as it may cause electric
shock. Contact the authorised
service before doing anything.
Plug the product into an earthed
•
socket. Earthing must be done by a
qualified electrician.
If the product has LED type lighting,
•
contact the authorised service for
replacing or in case of any problem.
Do not touch frozen food with wet
•
hands! It may adhere to your hands!
Do not place liquids in bottles and
•
cans into the freezer compartment.
They may explode.
Place liquids in upright position after
•
tightly closing the lid.
Do not spray flammable substances
•
near the product, as it may burn or
explode.
Do not keep flammable materials
•
and products with flammable gas
(sprays, etc.) in the refrigerator.
Do not place containers holding
•
liquids on top of the product.
Splashing water on an electrified
part may cause electric shock and
risk of fire.
Exposing the product to rain,
•
snow, sunlight and wind will cause
electrical danger. When relocating
the product, do not pull by holding
the door handle. The handle may
come off.
Take care to avoid trapping any part
•
of your hands or body in any of the
moving parts inside the product.
Do not step or lean on the door,
•
drawers and similar parts of the
refrigerator. This will cause the
product to fall down and cause
damage to the parts.
Take care not to trap the power
•
cable.
•
When positioning the appliance, ensure the
supply cord is not trapped or damaged.
•
Do not locate multiple portable socket-
outlets or portable power supplies at the
rear of the appliance.
1.1.1 HC warning
If the product comprises a cooling system using
R600a gas, take care to avoid damaging the
cooling system and its pipe while using and
moving the product. This gas is flammable.
If the cooling system is damaged, keep the
product away from sources of fire and ventilate
the room immediately.
C
The label on the inner left side
indicates the type of gas used in
the product.
1.1.2 For models with
water dispenser
Pressure for cold water inlet shall
•
be maximum 90 psi (620 kPa). If
your water pressure exceeds 80 psi
(550 kPa), use a pressure limiting
valve in your mains system. If you
do not know how to check your
water pressure, ask for the help of a
professional plumber.
If there is risk of water hammer
•
effect in your installation, always
4 /18EN
Refrigerator / User Manual