Installation; Right Place For Installation - Beko RDSE600M21W Manuel D'utilisation

3

Installation

3.1. Right place for installation

Call the Authorized Service Provider for installation
of the product. To make the product ready for use,
be careful that the electrical wiring and plumbing
are appropriate by referring to the information
in the user manual. If not, call a qualified
electrician and plumber and have the necessary
arrangements made.
B
WARNING:
for damages caused by operations by
unauthorized persons.
B
WARNING:
power plug of the product should not be
plugged in. Otherwise, there is a danger of
death or serious injury!
WARNING:
A
to where the product will be placed is
so narrow that the product cannot pass
through, pass the product by turning it to
side; otherwise, call an authorized service.
• To avoid shaking, place the product on a flat
surface.
• Install the product at least 30 cm away from
heat sources such as cooker, radiators, stove
and at least 5 cm away from electrical oven.
• Do not expose the product to direct sunlight and
do not store it in humid place.
• A suitable air circulation should be around
the product so that it can work efficiently. If
the product will be placed in a recessed wall,
take care that there is at least 5 cm of space
between the ceiling and the side walls.
• Do not install the product where the temperature
drops below 10 °C.
Refrigerator / User Manual
The manufacturer is not liable
During the installation, the
: If the doorway of the room
• Attach 2 plastic wedges as illustrated below.
Plastic wedges are intended to keep the
distance which will ensure the air circulation
between your refrigerator and the wall. (The
picture is drawn up as a representation and it
is not identical with your product.)
• Condenser of your refrigerator is on the rear
side. In order to increase the energy efficiency
by minimizing the power consumption, the
upper part of the condenser on the rear side
of the product must be pulled backwards
and locked as shown in the figure. When the
condenser is pulled back, the right and left
upper holders are locked and the position of
the condenser is fixed.
7/18 EN