Charge And Discharge Programs; Program Flowchart; Selecting The Charge Program Group - GRAUPNER 6442 Instructions D'utilisation

The various facilities of the charger are divided up into four program groups which you can select by
holding the MODE button pressed in for two seconds. The sequence is shown in the flow chart
below.
Ni-Cd battery programs: charging, conditioning, discharging to determine capacity or residual
capacity, or to select cells.
Ni-MH battery programs: charging, conditioning, discharging to determine capacity or residual
capacity, or to select cells.
LiPo / LiIo / LiFe battery programs: charging, discharging to determine capacity or residual capacity,
or to select cells.
Lead-acid battery programs: charging, discharging to determine capacity or residual capacity, trickle
charge for stand-by operation.
NiCd
MODE
AUTOMATIC-
program
MODE
MODE (2 sec.)
(2 sec.)
NiMH
MODE
AUTOMATIC-
program
MODE
MODE (2 sec.)
(2 sec.)
Lithium
MODE
MANUAL-
program
MODE
MODE (2 sec.)
(2 sec.)
Pb
MODE
MANUAL-
program
MODE
(2 sec.) MODE (2 sec.)
NiCd
AUTOMATIC
program
MODE (2 sec.)
NiMH
AUTOMATIC
program
MODE (2 sec.)
Lithium
MANUAL
program
MODE (2 sec.)
Pb
MANUAL
program
MODE (2 sec.)
22

6. Charge and discharge programs

7. Program flowchart

NiCd
MODE
MANUAL-
program
NiMH
MODE
MANUAL-
program
Lithium
MODE
discharge
program
Pb
MODE
discharge
program

8. Selecting the charge program group

In the interests of clarity, the charge and set-up facilities of the
ULTRAMAT 17 are divided into four logical program groups.
MODE
A separate program group is provided for each of the different
battery types: Nickel-Cadmium, Nickel-Metal-Hydride, Lithium-
Ion / Lithium-Polymer / LiFePO
MODE
A supplementary program group contains the individual adjust-
ment facilities for the charger overall.
Switching programs:
MODE
Changing from one charge program group to another is not
possible if the charger is currently engaged in a charge /
discharge process.
Changing from one program group to another is carried out using
MODE
the MODE button, which must be held pressed in for about two
seconds. A brief press on the MODE button makes changes within
the program group.
NiCd
MODE
discharge
program
program
NiMH
MODE
discharge
program
Lithium
MODE
type
select
NiCd
NiCd
MODE
∆ ∆ ∆ ∆ ∆
balance
delta-peak
trigger voltage
NiCd
NiMH
MODE
∆ ∆ ∆ ∆ ∆
delta-peak
balance
program
trigger voltage
and Pb (lead-acid) batteries.
4
MODE
MODE