Kobe Range Hoods CH7930SQB Manuel D'installation Et Mode D'emploi page 20

Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST BE PROPERLY GROUNDED.
MAKE SURE THIS IS DONE BY SPECIALIZED ELECTRICIAN IN ACCORDANCE WITH ALL
APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES. BEFORE CONNECTING
WIRES, SWITCH POWER OFF AT SERVICE PANEL AND LOCK SERVICE PANEL TO
PREVENT POWER FROM BEING SWITCHED ON ACCIDENTALLY.
Connect the electrical wires.
- Connect three wires (black, white and green) to house wires and cap with wire
connectors. Connect according to color: black to black, white to white, and green to
green.
- If necessary to hide the electrical wire connections, push wires back into the wiring box.
Access the wire connections underneath the hood. Make sure wires do not slip between
motor or any moving parts to prevent any damage.
Final Assembly
1. Attach oil tunnel. Refer to Figure 30.
Refer to Figure 31.  Slide the baffle filter into the hood.  Push the baffle filter upward.
2.
 Slide forward.  Pull downward.  Fit into place.
3. For bottom casing, repeat above steps. Refer to Page 23.
4. Turn power ON in control panel. Check all lights and fan operation.
5. Make sure to leave this manual for the homeowner.
Figure 30
18
Figure 31