METHODS OF BURNER
IGNITION
There are two ways to ignite the
burner. The first is by using the
ignition system built into your grill.
The second is with a match.
Next are the steps for igniting your
grill using the ignition system. On
the following page are steps for
igniting your grill with a match.
BURNER IGNITION & USAGE
BURNER IGNITION
A) Remove the lid (1).
m DANGER
Failure to remove the lid before igniting
the grill's burner, or not waiting five
minutes to allow the gas to clear if the
grill does not light, may result in an
explosive flare-up which can cause
serious bodily injury or death.
B) Make sure the regulator control knob is turned to the
OFF position (2). Check by pushing regulator control
knob in and turning it clockwise until it stops.
C) Confirm that the LP cylinder is properly installed.
D) Turn on the regulator control knob on by pushing it in
and turning it counterclockwise to HIGH (3).
E) Hold the handle on the cookbox. Push the red igniter
button several times, so it clicks each time (4).
F) Check that the burner is lit by looking through the
cooking grate. You should see a flame.
m WARNING: Do not lean over the open
grill while igniting.
m WARNING: If burner fails to ignite
within five seconds, stop, turn the
regulator control knob to OFF and wait
five minutes to allow the gas to clear
before you try again or light with a
match.
TO EXTINGUISH BURNER
Push regulator control knob in and turn it clockwise to the
OFF position.
1
2
3
4
WWW.WEBER.COM
11
®