PERFECTPRO DAB+Pro Mode D'emploi page 12

Clock time setting
Setting the time format
1. Press the Power On/Off button to turn on the radio.
2. Press and hold the Info/Menu button to access the menu for the current mode. Rotate the Tuning control
knob to select "System Setting" and press the Tuning control knob to enter the system settings menu.
3. Rotate the Tuning control knob to select "Time" and press the Tuning control knob to enter the setting.
4. Rotate the Tuning control knob to select "Set 12/24 hour" and press the Tuning control knob to enter
the setting..
5. Rotate the Tuning control knob to select 12 or 24 hour format and press the Tuning control knob to
confirm the setting. The selected format is used in standby mode and on the playing mode screen. If
the 12 hour clock format is chosen, the radio will then use the 12 hour clock with an AM indicator.
Automatically updating the clock
Your radio will normally update the clock automatically using the DAB or FM signal. If no signal is
available, then you need to set the time manually.
After a power failure the radio will then set its clock the next time that you turn on the radio in DAB or
FM mode. Alternatively you may specify that the time is not automatically updated. In this case the clock
must always be set manually after a power interruption.
1. With your radio switched on, press and hold the Info/Menu button to access the menu for the current
mode.
2. Rotate the Tuning control knob to select "System Setting" and press the Tuning control knob to enter
the system settings menu.
3. Rotate the Tuning control knob to select "Time". Press the Tuning control knob to enter the time setting
menu.
4. Rotate the Tuning control knob to select "Auto update" and press the Tuning control knob to enter the
setting.
5. Rotate the Tuning control knob to choose an update option from "No update" "Update from Any" "Update
from DAB" or "Update from FM" as required. Press the Tuning control knob to confirm your choice.
Note:
If you select "Update from Any", "Update from DAB", "Update from FM" the current time received will be
displayed. If no signal is found you should either position the radio so that a signal can be received, or
revert to manual clock mode.
Setting the clock manually
1. With your radio switched on, press and hold the Info/Menu button to access the menu for the current
mode.
2. Rotate the Tuning control knob to select "System Setting" and press the Tuning control knob to enter
the system settings menu.
3. Rotate the Tuning control knob to select "Time". Press the Tuning control knob to enter the time setting
menu.
11