Makita BJS130 Manuel D'instruction page 6

Removing cutting head
Use the hex wrench to loosen the three screws which
secure the cutting head. Pull the cutting head straight out
to remove it with turning it left and right alternately.
1
2
009017
Removing shear blades
1
2
3
5
4
009019
Remove the three screws which hold the cutting head.
When removing the second screw, be careful not to fall
the sleeve. Then the blades can be removed easily.
When removing the blades, hold the blades and the
sleeve so that they do not fall from the cutting head.
Installing shear blades
1
2
3
4
5
004690
Install the sleeve and tighten the three screws after
inserting the center blade, side blade L & R into the
cutting head. In this process, the screw heads should be
protruding 2 - 3 mm from the cutting head surface.
If you will tighten the screws excessively, the cutting
head cannot be installed to the tool.
Installing cutting head
CAUTION:
Secure the cutting head firmly. Otherwise it can
•
rotate during operation and can cause serious
injury.
1. Cutting head
2. Screws
3. Hex wrench
3
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Sleeve
1. Cutting head
2. Sleeve
3. Side blade R
4. Center blade
5. Side blade L
6
6. Screws
1
2
3
009016
Insert the cutting head into the tool with turning it left and
right alternately. Then tighten the three screws with the
hex wrench.
Replacing cutting head for capacity of
gauge 16 (Optional Accessory)
1. Remove the cutting head. (Refer to the section
titled " Removing cutting head ".)
009050
2. Loosen the bearing assembly with provided
wrench while keeping the spindle still by grabbing
the two flat parts on the spindle still with another
wrench.
009051
3. Remove the bearing assmbly (thin one) and screw
the bearing assembly for gauge 16 onto the spindle
and firmly tighten it with the provided wrench while
keeping the spindle still by placing another wrench on
the two flat surface on the spindle.
4. Install the optional cutting head by referring to the
section titled " Installing cutting head ".
CAUTION:
Do not confound the bearing assembly provided
•
on the tool (thin one) with that for cutting head for
capacity of gauge 16 (Optional Accessory). The
bearing assembly
while that for cutting head for capacity of gauge
6
1. Cutting head
2. Screws
3. Hex wrench
4. Tighten
4
provided on the tool is thin