Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connecting air hose
2
Lock the trigger. Slip the air socket of the air hose onto
the air fitting on the nailer. Be sure that the air socket
locks firmly into position when installed onto the air fit-
ting. A hose coupling must be installed on or near the tool
in such a way that the pressure reservoir will discharge at
the time the air supply coupling is disconnected.
OPERATION
CAUTION:
•
Make sure all safety systems are in working order
before operation.
1.
To drive a nail, you may place the contact element
against the workpiece and pull the trigger, or
1
2.
Pull the trigger first and then place the contact ele-
ment against the workpiece.
2
•
No. 1 method is for intermittent nailing, when you
wish to drive a nail carefully and very accurately.
No. 2 method is for continuous nailing.
CAUTION:
•
However when the tool is set to the "Intermittent
Nailing" mode, WITH THE TRIGGER HELD IN A
HALF-PULLED POSITION, an unexpected nailing
005468
1. Air fitting
1
2. Air socket
005469
005470
could occur, if contact element is allowed to re-con-
tact against the workpiece or the other surface
under the influence of recoil.
In order to avoid this unexpected nailing, perform as
follows;
A. Do not place the contact element against the work-
piece with excessive force.
B. Pull the trigger fully and hold it on for 1-2 seconds after
nailing.
•
For No. 1 method, set the change lever to the "Inter-
mittent Nailing" position.
For No. 2 method, set the change lever to the "Con-
tinuous Nailing" position.
After using the change lever to change the nailing
method, always make sure that the change lever is
properly set to the position for the desired nailing
method.
1
2
3
4
CAUTION:
•
Operating the tool without nails shortens the life of
the tool and should be avoided.
Air exhaust
Air exhaust direction can be changed easily by rotating
the exhaust cover. Change it when necessary.
Jammed nailer
CAUTION:
•
Always lock the trigger, disconnect the hose and
remove the nails from the magazine before clean-
ing a jam.
When the nailer becomes jammed, do as follows:
Open the door and magazine cap and remove the nail
coil. Insert a small rod or the like into the ejection port
and tap it with a hammer to drive out the nail jamming
from the ejection port. Reset the nail coil and close the
magazine cap and door.
6
004307
1. Continuous nail-
ing
2. Intermittent nail-
ing
3. Change lever
4. Trigger lock
005613
1. Exhaust cover
1
Publicité
Table des Matières
