Mounting The Frames; Pellets And Feeding - Dal Zotto INSERTO 700 ELITE CRYSTAL Manuel Utilisateur

MOUNTING THE FRAMES

Š Front frame
Š Side frames

PELLETS AND FEEDING

The pellet used must comply with the features described by
Standards
EN PLUS CLASS A1, ISO 17225 2 CLASS A1
and
UNI EN 303 5 with the following characteristics: water content ≤
12%, ash content ≤ 0.5% and lower calori c value >17 MJ/kg (in
the case of boilers).
To guarantee combustion without problems, the pellets must be
kept in a dry place.
We recommend using pellets with a diameter of 6 mm with our
products.
See the images for feeding pellets.
THE USE OF POOR QUALITY PELLETS OR ANY OTHER MATERIAL DAMAGES THE FUNCTIONS OF YOUR STOVE AND
CAN VOID THE WARRANTY AND THE RESPONSIBILITY OF THE MANUFACTURER .
OPEN THE TANK LID AND LOAD THE PELLETS USING A SCOOP.
IN THE EVENT OF THE INSERTS, ONLY LOAD WHEN THE MACHINE IS OFF AND COLD, BY EXTRACTING IT FROM THE
COMPARTMENT.
IN THE EVENT OF INSTALLATION WITH FEEDING KIT OPTIONAL THE MACHINE MUST NOT BE EXTRACTED.
N.B. Any wooden beams located above the insert must be protected
with non-in ammable material.
Frame assembly is important as it allows correct recirculation of the
air and consequently optimal product operation.
The 2 side frames are xed to the upper frame by means of 2 screws
each side.
The remaining holes on the side frames allow to x the entire frame
to the sides of the machine by means of self-drilling screws.
ENGLISH 47