Inserting Batteries In The Remote Control Handset; Switching The Tv On/Off; To Switch The Tv On; To Switch The Tv Off - Grandin LV32W10 Mode D'emploi

Inserting Batteries in the
Remote Control Handset
• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Place the batteries in the right directions and
replace the battery cover.
Note : Remove the battery from remote control handset when
it is not to be used for a long period. Otherwise it can be
damaged due to any leakage of batteries.
Remote range is approximately 7m/23ft.
02_[GB]_MB36_HDIDTV-MPEG4_BRONZE8_32875W_1205UK_10064576_50158417.indd 41

Switching the TV On/Off

To Switch the TV On

• Connect the power cord to the 220-240V AC, 50
Hz.
• Press " " switch. Then the standby LED lights
up.
• To switch on the TV from standby mode either:
• Press the " " button, P+ / P- or a numeric button
on the remote control.
• Press the -P/CH or P/CH+ button on the TV. The TV
will then switch on.
Note : If you switch on your TV via PROGRAMME UP/DOWN
buttons on the remote control or on the TV set, the programme
that you were watching last will be reselected.
By either method the TV will switch on.

To Switch the TV Off

• Press the " " button on the remote control or press
the " " switch, so the TV will switch to standby
mode.
• To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
English - 41 -
29.10.2009 08:45:39