SEVERIN KS 9819 Mode D'emploi page 14

4. Remove both adjustable feet and take off the lower
hinge plate.
5. Remove the hinge pin from the lower hinge plate and
screw it back into the opening next to it. (1↔2).
6. Attach the lower hinge plate on the other side. Do not
tighten the screws for the moment; this should only be
done once the door is in its proper closed position.
7. Replace the door in its new position. Ensure that the
hinge pin is inserted into the guide bushing (hole) on
the lower part of the door frame.
8. Attach the upper hinge plate (removed earlier in step
2) on the left-hand side with 2 screws. Ensure that the
hinge pin is inserted into the guide bushing (hole) on
the upper part of the door frame. Insert and tighten the
other 2 screws on the other side
9. Adjust the closed door to its proper position and tighten
the screws of the upper and lower hinge plates.
14
10. Replace the top panel and tighten the screws at the
back
11. Put the unit back in its intended position and wait for
about four hours before connecting it to the mains.
Freezer compartment door
1. Open the freezer compartment door.
2. Remove the screw on the lower hinge, take the hinge
off and carefully lower the door.
3. Unscrew and remove the stop plate for the door latch,
and fi t it on the other side.
4. Remove the collar from the hole on the right of the
housing and fi t it on the left.
5. Turn the door through 180° and push the hinge onto its
pin from below.
6. Replace and close the door, before tightening the hinge
screws.
Temperature control
∙ The unit is
re-activated by
connecting it to
the mains. It is
only switched
off completely when the plug is removed from the wall
socket.
∙ The temperature in the refrigerator cabinet can be
adjusted by setting the temperature control. Turning the
control clockwise will decrease the temperature, while
turning it anti-clockwise will increase it.
∙ Initially, the temperature control should be set to 6 or 7
(rapid cooling), but after 30 minutes it should be brought
back to a medium setting which is adequate for normal
home use.
∙ Caution: The control must not remain set at 6 or 7 for
more than three hours before being reduced to a medium
level – depending on the ambient temperature, the
interior temperature may otherwise drop too low.
∙ Following a power interruption, or if the unit has been
switched off on purpose, it may take 3 to 5 minutes
before it switches on again.
In position '0', the cooling function is switched off,
though the appliance is still connected to the mains.