Maintenance; Environment; Warranty; Technical Specifications - Toolland FT 92 Mode D'emploi

FT 92
Pos. 3 (Minimum)
Open the valve on the gas cylinder.

Put the control knob in 'Start position and

Maximum heating' (Pos.1) and press
down.
After 10 seconds – while holding the

control knob in pressed condition – push
the piezoelectric ignition button fully
down. It could be necessary to push the
piezo button several times before the
pilot is lighted. Each time you push the
piezo button down you will hear a clicking
sound as well as see a spark on the pilot
burner. This spark will light the pilot.
Once the pilot is lit, continue on holding

the gas control knob in the pressed
position for further 20 seconds. The
heater will heat at Maximum (Pos.1)
Now you can put the control knob in the

desired heating position. Pos.2 =
Medium, Pos.3 = Minimum.
To turn off the device, completely close

the gas cylinder valve.
Do not move the heater when it is

operating.

6. MAINTENANCE

Always turn off the appliance before

cleaning it and wait till it is cooled
completely.
To clean the outside of the heater, use a

soft cloth soaked with water and a liquid
detergent. Do not use scouring pads or
www.toolland.eu
abrasive products. Do not use water or
abrasive products.
Regularly inspect the atmosphere

analyzer and the aeration holes.
Regularly check the condition of the

connections. Check the condition of the
hose and the pressure regulator every
time the gas cylinder is changed.
Take care not to hit or damage the

surface of the burner, the fittings and gas
tubes, the tap and all the other
components of the gas circuit.
We recommend that you have the heater

inspected once a year by a qualified
professional.
If you decide not to use the heater for an

extended period, you must follow the
instructions bellow:
- Close the tap on the cylinder and
disconnect the pressure regulator
from the cylinder.
- Store the cylinder in a well-ventilated
room, far from inflammable or
explosive materials and preferably
outside your home. Never store the
cylinder in a basement or attic.
- The heater must be stored in a dry
place and protected from dust. It is
recommended to store the heater in
its original packaging.

7. ENVIRONMENT

Should your appliance need replacement
after extended use, do not put it in the
domestic waste but dispose of it in an
environmentally safe way.

8. WARRANTY

Refer to the enclosed warranty conditions for
the terms and conditions warranty.

9. TECHNICAL SPECIFICATIONS

Standen
Vermogen
Gas type
Gas Category
Mbar
Ignition
Consumption
English
3
3,2kW
Propaan/Butaan
I3+
28-30/37
Piezo
235g/u
20