Overheating Protection; Cleaning And Maintenance; Technical Specifications - Toolland TC78074 Mode D'emploi

6.3

Overheating Protection

The appliance is provided with an overheating protection. This protection will switch off the appliance
automatically when it notices a malfunction. In this case you must switch off the appliance and pull out the
supply cord. After a short period of cooling down, the appliance will be ready to use again.
When this happens repeatedly you must contact your local dealer.
7.

Cleaning and Maintenance

 Before cleaning the appliance disconnect it from the socket and let it cool down. The enclosure is easily to
get dirty. Wipe it often with a sponge. For every dirty parts wipe with a sponge dipped in water and mild
detergent. Then dry the heater enclosure with clean cloth.
 Be careful and do not let water enter the appliance. Do not splash water onto the heater, never use
solvents like gasoline, isoamyl, acetate toluene etc. to clean the heater, in order to protect the enclosure.
 Clean the cord and plug. Pack it dry in a plastic bag and store it in a dry and ventilated place.
8.

Technical Specifications

power supply
IP rating
power consumption
heating positions
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.toolland.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 01 – 03/07/2015
TC78074
230 VAC, 50 Hz
IPX4
3000 W
0 off
ventilator
2000 W
3000 W
5 ©Velleman nv