1 m
1 m
1.5 m
Select a permanent location for the Charging Dock, because every time you relocate it, your
NOTE:
robot will be required to completely re-map your house.
For best results, set up on bare floor or thin carpet.
NOTE:
Do not place dock against baseboards, heating elements, or in direct sunlight.
NOTE:
Choose a level surface in a central area. Remove any objects that are closer than 1 m (3 feet) from either
side of the dock, or closer than 1.5 m (5 feet) from the front of the dock. Place the dock with its back against
the wall. Plug the charging cord into an outlet. The indicator light on the dock will illuminate green when
the dock has power. The dock must be plugged in continuously for the robot to find it.
INSTALLING THE SIDE BRUSHES
sharkc le a n.com
DOCK SETUP
Snap the 2 included Side Brushes onto the square
pegs on the bottom of the robot.
IMPORTANT: The Shark IQ Robot™ has a pre-installed rechargeable battery. Battery should be fully charged
before using. It may take up to 6 hours to fully charge.
To charge, the Power button on the side of the robot
must be in the ON position (I). The robot will beep
when charging begins.
!
If the robot has no charge and cannot return to
the dock, manually place it on the dock. The dock
indicator light will flash blue and the robot will
beep when charging begins.
NOTE: When manually placing the robot on the dock, make sure the Charging Contacts on the bottom of the robot are
touching the ones on the dock. While the robot is charging, both blue LED lights will flash. When charging is complete, both
blue lights will illuminate steadily.
NOTE: When picking up the robot, be careful not to place fingers between the bumper and the base of the robot.
CHARGING
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the dock.
If your robot doesn't return to the dock, its charge
may have run out.
s ha rkc l ea n.co m