shark IQ ROBOT RV1000AE Série Guide D'utilisation page 9

MAINTENANCE
CLEANING AND REPLACING THE BASE FILTERS
Regularly clean and replace your filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
Remove the base dust bin, then lift out both Pre-
Motor Filters.
After emptying the dust bin, ensure there is no
debris or dust stuck on the filter mesh.
s h a r kc l e a n . c o m
Filter
Door
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the Filter Door, then
tilt the door and lift it off. Remove the Post-Motor
Filter from the base. To reinstall the post-motor
filter, insert it into the base and replace the filter
door.
NOTE: The pre-motor foam and felt filters should be
replaced every 2.5 years. The post-motor filter should
be replaced every 3 years.
NOTE: Clean the cyclone filter inside the dust bin with a
small brush once a month.
MAINTENANCE
SELF-CLEANING BRUSHROLL
The Self-Cleaning Brushroll removes debris over time as it cleans. If some debris remains wrapped around
the brushroll, continue cleaning to allow the brushroll to remove it.
If some debris remains on the brushroll after continued cleaning, follow the steps below to remove it.
To access the brushroll, push up on the tabs on the
brushroll access door, then lift off the door.
NOTE: When cutting away debris, be sure not to cut the brushroll.
NOTE: Replace brushroll every 6 to 12 months, or when visibly worn. See sharkaccessories.com for replacement parts.
Lift out the brushroll. Remove the cap on the end of
the brushroll. Clean off any debris, then reattach cap.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down until
both sides click into place.
s h a r kc l e a n . c o m