Whirlpool W11310003B Guide De L'utilisateur page 27

NOTES:
The Favorite Fill dispenser will automatically time out after
■
1 minute of inactivity.
You can refill several glasses with the same measurement by
■
continuing to touch FILL (center button) after each glass fill.
4. Dispense water.
NOTE: While dispensing water, the flow of water will
automatically stop once the desired volume has been
dispensed.
Press a sturdy glass against the dispenser paddle below
■
the water spout.
Place the glass below the water spout, and touch FILL
■
for hands-free dispensing.
5. To pause dispensing before the selected volume has been
dispensed, touch FILL a second time or touch the water
dispenser paddle. Touch FILL or paddle again to resume
dispensing remaining amount.
NOTE: If you stop dispensing before the desired volume has
been dispensed, the display will turn off after 1 minute. If you
have not resumed by then, it will reset back to the original
amount.
6. To select a new volume or start dispensing the same volume
again, you must first finish dispensing the selected volume
or turn off the Favorite Fill feature (either by waiting 1 minute
so it will automatically turn off or by touching CUBED ICE
or CRUSHED ICE to manually turn it off), and then select
Favorite Fill again.
The Ice Dispenser
IMPORTANT:
If the ice cubes are hollow or have an irregular shape, it could
■
be because of low water pressure. See the "Water Supply
Requirements" section.
Ice travels from the ice storage bin through the dispenser
■
chute to the dispenser. To turn off the ice maker, see the
"Ice Maker and Storage Bin" section.
The dispenser may continue to make noise and ice may
■
continue to dispense for several seconds after releasing
the dispenser button or paddle.
To Clean the Ice Dispenser Chute:
Humidity causes ice to naturally clump together. Ice particles can
build up until the ice dispenser chute becomes blocked.
If ice is not dispensed regularly, it may be necessary to empty the
ice storage bin and clean the ice delivery chute, the ice storage
bin, and the area beneath the storage bin every 2 weeks.
If necessary, remove the ice clogging the storage bin and
■
delivery chute using a plastic utensil.
Clean the ice delivery chute and the bottom of the ice storage
■
bin using a warm, damp cloth, and then dry thoroughly.
OR
To Dispense Ice—Paddle Dispensing
1. Select the desired type of ice by pressing CUBED ICE or
CRUSHED ICE.
WARNING
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the dispenser paddle. Hold the
glass close to the dispenser opening, so ice does not fall
outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to
the paddle to activate the ice dispenser. Pressing hard will not
make the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds after
removing the glass from the dispenser paddle. The dispenser
may continue to make noise for a few seconds after dispensing.
The Dispenser Drip Tray
!
The drip tray can be removed to carry to the sink to empty
Replace
Filter
Order Filter
!
or clean. !
Lift up on the front edge of the tray and pull forward to
■
remove.
The drip tray can also slide out to assist in Measured/
■
Favorite Fill.
Cut Hazard
a1 oz = b1 L
"#$#! a2 oz = b2 L !
Door Calibration
! a3 oz = b3 L !
Ajar
!
Dispense
!
!
!
%&#'#(')!"#$# !
!
27