Table Des Matières; Owner Responsibility; Product Description; Introduction - Husqvarna K 770 Vac Manuel D'utilisation

Introduction..................................................................... 2
Safety..............................................................................5
Assembly...................................................................... 13
Operation...................................................................... 16
Maintenance................................................................. 22

Owner responsibility

WARNING: Cutting, especially when DRY
cutting, generates dust that comes from the
material being cut, which frequently contains
silica. Silica is a basic component of sand,
quartz, brick clay, granite and numerous
other minerals and rocks. Exposure to
excessive amount of such dust can cause:
Respiratory disease (affecting your ability to
breath), including chronic bronchitis, silicosis
and pulmonary fibrosis from exposure to
silica. These diseases may be fatal;
Skin irritation and rash.
Cancer according to NTP* and IARC* */
National Toxicology Program, International
Agency for Research on Cancer.
Take precautionary steps:
Avoid inhalation of and skin contact with
dust, mist and fumes.
Proposition 65

Product description

This Husqvarna power cutter is a portable handheld cut-
off machine powered by a two-stroke combustion
engine. The product has a blade guard, a blade guard
extender and a dust shield that collect particles and
sparks and move them away from the operator. The
product operates with an external dust extractor.
2
Contents

Introduction

WARNING
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects
or other reproductive harm.
Troubleshooting............................................................ 27
Transportation, storage and disposal........................... 29
Technical data.............................................................. 30
Warranty....................................................................... 31
Wear and ensure that all bystanders wear
appropriate respiratory protection such as
dust masks designed to filter out
microscopic particles. (See OSHA 29 CFR
Part 1926.1153)
To minimize dust emissions, wet cut when
feasible. If dry cutting is necessary, use an
appropriate dust extractor.
It is the owner's/employer's responsibility that the
operator has sufficient knowledge about how to use the
product safely. Supervisors and operators must have
read and understood the Operator's Manual. They must
be aware of:
• The products's safety instructions.
• The products's range of applications and limitations.
• How the product is to be used and maintained.
National/Local regulations could restrict the use of this
product. Find out what regulations are applicable where
you work before you start using the product.

Intended use

The product is used to cut hard materials as concrete,
masonry and stone. Do not use the product for other
tasks. The product must only be used by professional
operators with experience.
705 - 002 - 12.11.2018