Broncolor HMI 575.800 Mode D'emploi page 4

12. To protect against effects of radiated heat, the lamp base HMI F575.800 must not be
pointed at flammable surfaces and/or surfaces sensitive to heat, UV sensitive objects or
any living beings from less then 2 meters away. When used at a close-up range, (more
than 2m) limit the exposure time of unprotected skin.
13. Always unplug ballast unit and lamp base before cleaning or servicing and when not in
use. Never jerk cable to pull plug from socket. Grasp plug and pull to disconnect.
14. Let ballast unit and lamp base cool completely before storing. When putting away and
winding up cables, ensure that they do not come into contact with hot parts of the units.
15. To reduce risk of electric shock, do not immerse the lamp base or the ballast unit in water
or other liquids.
16. Lamp bases and ballast units are not suitable for application in wet or explosion-hazard
environments.
17. Protect the ballast unit and the lamp base from water and from excessive exposure to
dust. Avoid operating with wet hands.
18. To reduce the risk of electric shock, do not open this appliance, but take it to a qualified
service person when service or repair work is required. Incorrect reassembly can cause
electric shock when the appliance is used subsequently.
19. The use of an accessory attachment not recommended by the manufacturer may cause a
risk of fire, electric shock, or injury to persons.
20. In order to prolong the service life of the lamp the heat-up process of approx. 1 minute
should not be interrupted.
21. Prior to replacing fuses, lamp or protecting glass, disconnect the ballast unit from mains
power supply.
22. The ballast unit HMI 575.800 can only be used with the lamp base HMI F575.800.
3