Troubleshooting; Repairs - ROTOR Gastronom GT95 Mode D'emploi

CH-3661 Uetendorf

11. TROUBLESHOOTING

PROBLEM
The appliance doesn't run
The motor only runs at highest speed
when the appliance is switched on
The motor is difficult or impossible to
adjust
The motor stops under load
The motor continues to run even after
the bowl has been lifted

12. REPAIRS

Obtain the address of your nearest authorized Rotor Lips service center, from the store
where you purchased your appliance.
Repairs on electrical appliances should only be carried out by
professional technicians. Serious dangers to the user could result from
improper carried out repairs.
Attention!
If the appliance's mains cable should become damaged, it
should only be replaced with an original cable.
Instruction Manual
Rotor Gastronom GT95
CAUSE / SOLUTION
- See chapter "Safety features and
Protection"; overload switches
- Make sure the mains cable is plugged into a
wall socket
- Check the fuse in the applicable building
electrical circuit
- Brushes worn (more than 1 000 operating
hours) contact your service center
- Defective electronics (service center)
- Defective potentiometer or electronics
(service center)
- The overload switch has been activated
- Brushes worn (service center)
- Defective electronics (service center)
- Defective safety switch or electronics
(service center)
© Rotor Lips AG
17