Troubleshooting; Repairs; Disposal / Recycling; Guarantee - ROTOR MEMORY BLENDER RMB 2 Mode D'emploi

© Rotor Lips AG

13. TROUBLESHOOTING

PROBLEM
The appliance doesn't run
The motor only runs at highest speed
when the appliance is switched on
The motor stops under load
All buttons on control panel flash
(Memory Blender)

14. REPAIRS

Obtain the address of your nearest authorized Rotor Lips Service Centre, from the store
where you purchased your appliance.
Repairs on electrical appliances should only be carried out by
professional technicians. Use only genuine spare parts. Serious dan-
gers to the user could result from improper carried out repairs.
Attention!
If the appliance's mains cable should become damaged, it
should only be replaced by a professional technician with an
original cable. (Do not forget to branch grounding!)

15. DISPOSAL / RECYCLING

Disposal of the resulting work waste materials (e.g. food packaging, peelings
etc.) must be carried out according to the local regulations.
All individual components of the unit have to be treated according to the local
regulations for recycling (e.g. metal etc.) or safe disposal (e.g. P.C. board etc.).
This product should not be treated as household waste.

16. GUARANTEE

The terms of the guarantee are in accordance with the sales and delivery regulations of
Rotor Lips Ltd. Transport damages are not paid.
24
Instruction Manual
Rotor Memory Blender 2
CAUSE / SOLUTION
- See chapter "Motor Protection"; overload
switches
- Make sure the mains cable is plugged into a
wall socket
- Check the fuse in the applicable building
electrical circuit
- Brushes worn (more than 1 000 operating
hours) contact your Service Centre
- Sound enclousure is open - see chapter
"Safety Features"
- Defective electronics (Service Centre)
- The overload switch has been activated
- Brushes worn (Service Centre)
- Defective electronics (Service Centre)
- Dangerous fault: Do not continue to use
(Service Centre)