Electrical Connection; Putting Into Operation - ROTOR Gastronom GT95 Mode D'emploi

Instruction Manual
Rotor Gastronom GT95
CH-3661 Uetendorf
© Rotor Lips AG

5. ELECTRICAL CONNECTION

The power supply voltage must correspond to the values on the
rating plate on the appliance (the voltage rating is given in volts [V]
The appliance should only be connected to a single phase grounded
alternating current. Make sure that the original mains cable and
the wall outlet correspond.
The use of a faulty-energy-protection switch, (FI) is suggested by all the works with
electro-appliances.
Appliances with a 230 V designation can also be used with a 220 V mains supply.
If at all possible, avoid using an extension cord. If it is unavoidable, only proper, approved
extension cords should be used.
Do not subject the mains cable to strong tension or pressure.
To replace the cable, see chapter «Repairs».

6. PUTTING INTO OPERATION

Before using the appliance for the first time it must be thoroughly cleaned.
Follow the instructions in the chapter «Cleaning».
Place the Rotor Gastronom on a firm, flat base and plug it into a nearby, appropriate
electrical outlet.
Note
The windings of the Rotor commutator motors are covered with high-quality insulating
lacquer. For this reason, the motor may, at first, exude an odour when it heats up.
This is normal and does not damage the motor; it disappears after the motor has been
used several times.
7. OPERATING INSTRUCTIONS
Container assembly
- Insert the cutter head together with the gasket into the threaded ring.
- Screw the bowl turning counter clockwise into the threaded ring.
- Always ensure that it is inserted straight.
The cutter blades are sharp and may cause bad injuries.
14