Skil DL527502 Guide D'utilisation page 14

Torque-Adjustment Ring
Your tool features 17+1 clutch settings. Output
torque will increase as the clutch ring is rotated
from 1 to 17. The drill "
lock the clutch to permit drilling and driving for
heavy-duty work (Fig. 6).
When using the drill driver for different driving
applications, increase or decrease the torque in
order to help prevent damaging screw heads,
threads, workpiece, etc.
The proper setting depends on the job and the
type of bit, fastener, and material you will be
using. In general, use greater torque for larger
screws. If the torque is too high, the screws
may be damaged or broken. For delicate
operations, such as removing a partially
stripped screw, use a low torque setting. For operations such as drilling into hardwood, use a
higher torque setting.
CAUTION
LED Worklight
Your tool is equipped with an LED worklight,
located on the base of the tool, that illuminates
when the variable-speed trigger switch is
squeezed. This provides additional light on the
surface of the workpiece for operation in lower-
light areas (Fig. 7).
The LED worklight will automatically turn on
with a slight squeeze on the trigger switch
before the tool starts running, and will turn off 8
to 12 seconds after the trigger is released.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
are overloaded, the LED worklight will rapidly
flash. Rest the tool for a while or place the tool and battery pack separately under air flow for
cooling.
The LED worklight will flash more slowly to indicate that the battery is at low-battery capacity.
Recharge the battery pack.
14
" position will
Do not adjust the torque when the tool is running.
Fig. 6
Torque-
Adjustment
Ring
Fig. 7
LED
Worklight
Torque Setting
Torque
Indicator